Windows 10 Screen Tearing: Removing the Horizontal Split Lines in Games and Videos

During fast movement in a game or a panning shot in a film, the picture seems to split horizontally, with the top and bottom halves slightly out of line. That is screen tearing, and Windows 10 screen dewaasia tearing is especially noticeable on fast-paced games and scrolling pages.

Tearing happens when the graphics card sends a new frame while the monitor is still drawing the previous one. The screen then shows parts of two frames at the same time.

It is a timing problem rather than a fault, and there are several ways to bring the graphics card and monitor into step.

The best method depends on your monitor and graphics card.

What Usually Triggers It

Tearing appears for these reasons:

• The game runs at a frame rate different from the monitor’s refresh rate, with V-Sync off.
• Adaptive sync features such as G-SYNC or FreeSync are disabled or unsupported.
• The monitor is set to a lower refresh rate than it supports.
• The game runs in a windowed mode that bypasses certain sync features.

Tearing is most visible when frame rates are much higher than the monitor’s refresh rate.

First Steps to Try

Use built-in sync options.

1. Open the game’s graphics settings and turn on V-Sync.
2. If the game offers a frame rate limit, set it to your monitor’s refresh rate, such as 60 or 144.
3. Check Settings > System > Display > Advanced display settings and make sure the refresh rate is set to the monitor’s maximum.
4. Try the game in full-screen mode rather than windowed.
5. Restart the game and test again.

V-Sync removes tearing but can add slight input delay, which competitive gamers sometimes notice.

If the Problem Continues

Use adaptive sync and driver settings.

1. If your monitor supports FreeSync or G-SYNC Compatible, enable it in the monitor’s on-screen menu.
2. Enable G-SYNC in NVIDIA Control Panel or FreeSync in AMD Software.
3. Update the graphics driver.
4. In the graphics control panel, try “Fast Sync” or “Enhanced Sync” if available.
5. Use DisplayPort if the monitor’s adaptive sync works only over that connection.

Adaptive sync lets the monitor match the graphics card’s frame rate, which removes tearing with less delay than traditional V-Sync.

Protect Your Data First

Changing graphics settings does not affect files. Avoid forcing refresh rates beyond what the monitor supports. If the screen goes black after a change, wait for Windows to revert it.

The Bottom Line

Screen tearing is a timing mismatch between the graphics card and monitor. Turn on V-Sync or a frame limit, set the correct refresh rate, and enable adaptive sync if supported.

Different games respond differently to sync settings, so it is worth testing each option in the games you play most.